The Implications of Burning a Blend of Waste Materials in a Fluidizied Bed Combustor

[+] Author and Article Information
I. Gulyurtlu, P. Abelha, D. Boavida, J. Seabra, S. Gomes, N. Chaleta, I. Cabrita

Edificio J, DEECA-INETI, Azinhaga dos Lameiros, Estrada Paço do Lumiar 22, 1649-038 Lisboa, Portugal

J. Energy Resour. Technol 128(2), 118-122 (Jan 30, 2006) (5 pages) doi:10.1115/1.2191504 History: Received June 14, 2004; Revised January 30, 2006

A mixture involving wood, plastics, paper, and textile materials was burned in a fluidized bed combustor to monitor the gaseous emissions and to analyze the ashes collected in different locations of the installation. The ashes collected were first analyzed to verify the partitioning of heavy metals in different ash streams. They were then subjected to leaching tests to verify the solubility of different components present. There is a growing interest in utilizing wastes, which cannot be recycled for further use, for energy, particularly in Europe as the amounts are great and the cost of depositing them in landfills has become very considerable. These wastes are considered renewable sources and the recent policy is to encourage their use for energy, especially for decentralized energy production. However, these wastes may be contaminated and have to be verified that their utilization for energy does not bring about any adverse consequences on the environment. Each component making up the blend to be used as fuel needs to be analyzed to determine not only its composition but also its heating value so that the final blend to be prepared could present minimum risk for emissions of pollutants, ideally less than coal and with a heating value comparable, at least, to that of coal. The results obtained suggest that (i) the combustion efficiency was very high, (ii) there was an enrichment of ashes with heavy metals in the cyclones compared to the bed material, (iii) the gaseous pollutants were below the permitted limits, and (iv) the ashes did not have tendency for leaching. Such mixtures could, therefore, be used as a solid fuel in industry as a substitution for coal or heavy fuel oil.

Copyright © 2006 by American Society of Mechanical Engineers
Your Session has timed out. Please sign back in to continue.



Grahic Jump Location
Figure 2

Temperature profile of the combustor

Grahic Jump Location
Figure 3

On-line pollutants gas emission concentration

Grahic Jump Location
Figure 4

Gaseous pollutants and particulate emissions versus regulated levels (10)

Grahic Jump Location
Figure 5

Total ash formation and distribution between the output streams

Grahic Jump Location
Figure 6

Cl and Hg distribution between the output streams

Grahic Jump Location
Figure 7

Cr and Ni concentration between the output ash streams

Grahic Jump Location
Figure 1

Fuel feed rate profile during the waste blend combustion



Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In