Research Papers: Energy Systems Analysis

Modeling Hybrid Nuclear Systems With Chilled-Water Storage

[+] Author and Article Information
Corey T. Misenheimer

Department of Mechanical and
Aerospace Engineering,
North Carolina State University,
911 Oval Drive,
Box 7910, NCSU Campus,
Raleigh, NC 27695
e-mail: ctmisenh@ncsu.edu

Stephen D. Terry

Department of Mechanical and
Aerospace Engineering,
North Carolina State University,
911 Oval Drive,
Box 7910, NCSU Campus,
Raleigh, NC 27695
e-mail: sdterry@ncsu.edu

Contributed by the Advanced Energy Systems Division of ASME for publication in the JOURNAL OF ENERGY RESOURCES TECHNOLOGY. Manuscript received November 13, 2015; final manuscript received June 3, 2016; published online June 27, 2016. Assoc. Editor: S. O. Bade Shrestha.

J. Energy Resour. Technol 139(1), 012002 (Jun 27, 2016) (9 pages) Paper No: JERT-15-1437; doi: 10.1115/1.4033858 History: Received November 13, 2015; Revised June 03, 2016

Air-conditioning loads during the warmer months of the year are large contributors to an increase in the daily peak electrical demand. Traditionally, utility companies boost output to meet daily cooling load spikes, often using expensive and polluting fossil fuel plants to match the demand. Likewise, heating, ventilation, and air conditioning (HVAC) system components must be sized to meet these peak cooling loads. However, the use of a properly sized stratified chilled-water storage system in conjunction with conventional HVAC system components can shift daily energy peaks from cooling loads to off-peak hours. This process is examined in light of the recent development of small modular nuclear reactors (SMRs). In this study, primary components of an air-conditioning system with a stratified chilled-water storage tank were modeled in FORTRAN 95. A basic chiller operation criterion was employed. Simulation results confirmed earlier work that the air-conditioning system with thermal energy storage (TES) capabilities not only reduced daily peaks in energy demand due to facility cooling loads but also shifted the energy demand from on-peak to off-peak hours, thereby creating a more flattened total electricity demand profile. Thus, coupling chilled-water storage-supplemented HVAC systems to SMRs is appealing because of the decrease in necessary reactor power cycling, and subsequently reduced associated thermal stresses in reactor system materials, to meet daily fluctuations in cooling demand. Also, such a system can be used as a thermal sink during reactor transients or a buffer due to renewable intermittency in a nuclear hybrid energy system (NHES).

Copyright © 2017 by ASME
Your Session has timed out. Please sign back in to continue.


Aydogan, F. , Black, G. , Black, M. A. T. , and Solan, D. , 2015, “ Quantitative and Qualitative Comparison of Light Water and Advanced Small Modular Reactors,” ASME J. Nucl. Eng. Radiat. Sci., 1(4), p. 041001. [CrossRef]
Ingersoll, D. T. , Houghton, Z. J. , Bromm, R. , and Desportes, C. , 2014, “ Integration of NuScale SMR With Desalination Technologies,” ASME Paper No. SMR2014-3392.
Ingersoll, D. T. , Houghton, Z. J. , Bromm, R. , and Desportes, C. , 2014, “ NuScale Small Modular Reactor for Co-Generation of Electricity and Water,” Desalination, 340, pp. 84–93. [CrossRef]
Ingersoll, D. , Houghton, Z. , Bromm, R. , Desportes, C. , McKellar, M. , and Boardman, R. , 2014, “ Extending Nuclear Energy to Non-Electrical Applications,” 19th Pacific Basin Nuclear Conference, Vancouver, BC, Canada, Aug. 24–28, Paper No. PBNC2014-209.
Lubis, L. L. , Dincer, I. , and Rosen, M. A. , 2010, “ Life Cycle Assessment of Hydrogen Production Using Nuclear Energy: An Application Based on Thermochemical Water Splitting,” ASME J. Energy Resour. Technol., 132(2), p. 021004. [CrossRef]
Harvego, E. A. , McKellar, M. G. , Sohal, M. S. , O'Brien, J. E. , and Herring, J. S. , 2010, “ System Evaluation and Economic Analysis of a Nuclear Reactor Powered High-Temperature Electrolysis Hydrogen-Production Plant,” ASME J. Energy Resour. Technol., 132(2), p. 021005. [CrossRef]
Hammache, A. , and Bilgen, E. , 1992, “ Nuclear Hydrogen Production Based on Sulfuric Acid Decomposition Process,” ASME J. Energy Resour. Technol., 114(3), pp. 227–234. [CrossRef]
Mazloum, Y. , Sayah, H. , and Nemer, M. , 2016, “ Static and Dynamic Modeling Comparison of an Adiabatic Compressed Air Energy Storage System,” ASME J. Energy Resour. Technol., 138(6), p. 062001. [CrossRef]
Papaioannou, I. T. , Purvins, A. , Shropshire, D. , and Carlsson, J. , 2014, “ Role of a Hybrid Energy System Comprising a Small/Medium-Sized Nuclear Reactor and a Biomass Processing Plant in a Scenario With a High Deployment of Onshore Wind Farms,” J. Energy Eng., 140(1), p. 04013005. [CrossRef]
Orhan, M. F. , Dincer, I. , Naterer, G. F. , and Rosen, M. A. , 2010, “ Coupling of Copper-Chloride Hybrid Thermochemical Water Splitting Cycle With a Desalination Plant for Hydrogen Production from Nuclear Energy,” Int. J. Hydrogen Energy, 35(4), pp. 1560–1574. [CrossRef]
Li, Y. , Cao, H. , Wang, S. , Jin, Y. , Li, D. , Wang, X. , and Ding, Y. , 2014, “ Load Shifting of Nuclear Power Plants Using Cryogenic Energy Storage Technology,” Appl. Energy, 113, pp. 1710–1716. [CrossRef]
Forsberg, C. , 2013, “ Hybrid Systems to Address Seasonal Mismatches Between Electricity Production and Demand in Nuclear Renewable Electrical Grids,” Energy Policy, 62, pp. 333–341. [CrossRef]
Suri, R. K. , Al-Marafie, A. M. R. , Maheshwari, G. P. , Al-Juwaydal, F. , Al-Jandal, S. , Al-Madani, K. , and Aburshaid, H. , 1989, “ Experimental Investigation of Chilled Water Storage Technique for Peak Power Shaving,” Int. J. Refrig., 12(4), pp. 213–219. [CrossRef]
Al-Marafie, A. M. R. , 1987, “ Stratification Behaviour in a Chilled Water Storage Tank,” Int. J. Refrig., 10(6), pp. 364–366. [CrossRef]
Karim, M. A. , 2010, “ Experimental Investigation of a Stratified-Chilled Water Thermal Storage System,” Appl. Therm. Eng., 31(11–12) pp. 1853–1860.
Shin, M. S. , Kim, H. S. , Jang, D. S. , Lee, S. N. , Lee, Y. S. , and Yoon, H. G. , 2003, “ Numerical and Experimental Study on the Design of a Stratified Thermal Storage System,” Appl. Therm. Eng., 24(1), pp. 17–27. [CrossRef]
Nelson, J. E. B. , Balakrishnan, A. R. , and Murthy, S. S. , 1998, “ Experiments on Stratified Chilled-Water Tanks,” Int. J. Refrig., 22(3), pp. 216–234. [CrossRef]
Nelson, J. E. B. , Balakrishnan, A. R. , and Murthy, S. S. , 1999, “ Parametric Studies on Thermally Stratified Chilled Water Storage Systems,” Appl. Therm. Eng., 19(1), pp. 89–115. [CrossRef]
Osman, K. , Khaireed, S. M. N. A. , Ariffin, M. K. , and Senawi, M. Y. , 2008, “ Dynamic Modeling of Stratification for Chilled Water Storage Tank,” Energy Conserv. Manage., 49(11), pp. 3270–3273. [CrossRef]
Zhang, Z. , Turner, W. D. , Chen, Q. , Xu, Q. , and Deng, S. , 2011, “ Tank Size and Operating Strategy Optimization of a Stratified Chilled Water Storage System,” Appl. Therm. Eng., 31(14–15), pp. 2656–2664. [CrossRef]
Duda, S. W. , 2014, “ Avoid Outdated Condenser Water Rules-of-Thumb,” ASHRAE J., 56(3), pp. 50–54.
Baker, D. R. , 1984, Cooling Tower Performance, Chemical Publishing Company, New York, pp. 79–106.
Hill, G. B. , Pring, E. J. , and Osborn, P. D. , 1990, Cooling Towers Principles and Practice, Butterworth-Heinemann, Rushden, UK, pp. 140–145.
Baker, D. R. , and Shryock, H. A. , 2012, “ A Comprehensive Approach to the Analysis of Cooling Tower Performance,” SPX Cooling Technologies, Kansas City, KS.
Evapco, 2015, “AT Cooling Tower—Thermal Performance,” Evapco Inc., Taneytown, MD.
Daeil Aqua, Ltd., 2000, “Cooling Tower Technical Site of Daeil Aqua Co., Ltd. for Cooling Tower Engineers, Operators, and Purchases,” Daeil Aqua Ltd., Gyeongsangnam-Do, South Korea.
Kloppers, J. C. , and Kroger, D. G. , 2005, “ Cooling Tower Performance Evaluation: Merkel, Poppe and e-NTU Methods of Analysis,” ASME J. Eng. Gas Turbines Power, 127(1), pp. 1–7. [CrossRef]
Stewart, W. E. , 2000, “ Improved Fluids for Naturally Stratified Chilled Water Storage Systems,” ASHRAE Trans.: Res., 106(1), pp. 264–276.
Spall, R. E. , 1998, “ A Numerical Analysis of the Stratification Properties of Chilled Water Storage Tanks Charged at the Freezing Point Temperature,” ASME J. Heat Transfer, 120(1), pp. 271–274. [CrossRef]
Musser, A. , and Bahnfleth, W. P. , 1998, “ Evolutions of Temperature Distributions in a Full-Scale Stratified Chilled-Water Storage Tank With Radial Diffusers,” ASHRAE Trans.: Res., 104, pp. 55–67.
Musser, A. , and Bahnfleth, W. P. , 2001, “ Parametric Study of Charging Inlet Diffuser Performance in Stratified Chilled Water Storage Tanks With Radial Diffusers: Part 1—Model Development and Validation,” ASHRAE Trans.: Res., 7(1), pp. 22–40.
Kaloudis, E. , Grigoriadis, D. G. E. , Papanicolaou, E. , and Panidis, T. , 2014, “ Large Eddy Simulation of Thermocline Flow Phenomena and Mixing During Discharging of an Initially Homogeneous or Stratified Storage Tank,” Eur. J. Mech., B: Fluids, 48, pp. 94–114. [CrossRef]


Grahic Jump Location
Fig. 2

Schematic of proposed hybrid nuclear system

Grahic Jump Location
Fig. 3

Electric, centrifugal chiller efficiency curves established via Carrier's hap software

Grahic Jump Location
Fig. 4

Cooling tower characteristic curves of 775 nominal ton Evapco counterflow cooling tower

Grahic Jump Location
Fig. 5

Stratified chilled-water storage tank when charging (left) and discharging (right)

Grahic Jump Location
Fig. 6

Required electricity to meet cooling demand compared to proposed chilled-water storage system with a 6 × 106 gallon stratified chilled-water storage tank with assumed 10% CWL from 1:00 am on July 5 to 1:00 am on July 8

Grahic Jump Location
Fig. 7

Normalized cold water volume in tank with variable chiller size, 6 × 106 gallon storage tank, and 10% CWL from 1:00am on July 5 to 1:00 am on July 8

Grahic Jump Location
Fig. 8

Total required facility power to meet cooling loads and internal loads with no chilled-water storage versus facility with 6 × 106 gallon storage tank, constant 10% CWL, and variable chiller size from 1:00 am on July 5 to 1:00 am on July 8

Grahic Jump Location
Fig. 9

Total energy consumed for the same facility with and without thermal storage capabilities and total energy shifted from on-peak to off-peak hours on a monthly basis with a 6 × 106 gallon storage tank, 2000 kW chiller, and 10% CWL

Grahic Jump Location
Fig. 10

Normalized cold water volume in tank with variable CWL, 6 × 106 gallon storage tank, and a 2000 kW electric chiller from 1:00 am on July 5 to 1:00 am on July 8

Grahic Jump Location
Fig. 11

Required chiller compressor input power as a function of tank size and variable CWL factor for specific chiller control criterion



Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In