By positioning the completely rough wall locally on the hub side diffuser wall alone in the vaneless diffuser, the flow rate of rotating stall inception was decreased by 42% at a small pressure drop less than 1%. This is based on the fact that the local reverse flow occurs firstly in the hub side in most centrifugal blowers with the backswept blade impeller. The 3-D boundary layer calculation shows that the increase in wall shear component normal to the main-flow direction decreases markedly the skewed angle of the 3-D boundary layer, and results in suppression of the 3-D separation. It is also clarified theoretically that the diffuser pressure recovery is hardly deteriorated by the rough wall positioned downstream of R = 1.2 because the increase in the radial momentum change, resulting from reduction in the skewed angle of the 3-D boundary layer, supports the adverse pressure gradient.
- International Gas Turbine Institute
Suppression of Rotating Stall by Wall Roughness Control in Vaneless Diffusers of Centrifugal Blowers
- Views Icon Views
- Share Icon Share
- Search Site
Ishida, M, Sakaguchi, D, & Ueki, H. "Suppression of Rotating Stall by Wall Roughness Control in Vaneless Diffusers of Centrifugal Blowers." Proceedings of the ASME Turbo Expo 2000: Power for Land, Sea, and Air. Volume 1: Aircraft Engine; Marine; Turbomachinery; Microturbines and Small Turbomachinery. Munich, Germany. May 8–11, 2000. V001T03A035. ASME. https://doi.org/10.1115/2000-GT-0461
Download citation file: