When an annular bed of solid particles that surrounds a cylindrical high-energy explosive core gets radially dispersed after detonation, the expanding front of particles undergoes instabilities. One of the possible causes of the instabilities is an inhomogeneous initial distribution of particles. This study explores this possibility by introducing two-dimensional perturbations to the initial distribution of particles within the annular bed and quantifying the growth of these perturbations over time using two-dimensional simulations. The initial perturbations are in the form of superposition of up to three sinusoidal azimuthal modal variations in the initial particle volume fraction (PVF, ratio of particle to cell volume). These are observed to impact the particle distribution at later times through a channeling instability whose effects are: (i) to decrease the velocity in regions of larger particle volume (PV) and (ii) to facilitate circumferential particle migration into the slow moving high PV sectors. These departures from axisymmetry are quantified by introducing two metrics. The effect of varying the number of azimuthal modes contained in the initial PVF perturbation, along with their amplitudes, wavelengths, and relative phases is investigated. The proposed metrics do not vary substantially with the relative phases; however, there is a strong variation in the metrics due to changes in the wavenumber. Unimodal perturbations were found to amplify both metrics the most.
Skip Nav Destination
Article navigation
September 2019
Research-Article
Early Time Evolution of Circumferential Perturbation of Initial Particle Volume Fraction in Explosive Cylindrical Multiphase Dispersion
M. Giselle Fernández-Godino,
M. Giselle Fernández-Godino
Department of Mechanical and Aerospace
Engineering,
University of Florida,
Gainesville, FL 32611
e-mail: gisellefernandez@ufl.edu
Engineering,
University of Florida,
Gainesville, FL 32611
e-mail: gisellefernandez@ufl.edu
Search for other works by this author on:
Frederick Ouellet,
Frederick Ouellet
Department of Mechanical and Aerospace
Engineering,
University of Florida,
Gainesville, FL 32611
e-mail: f.ouellet@ufl.edu
Engineering,
University of Florida,
Gainesville, FL 32611
e-mail: f.ouellet@ufl.edu
Search for other works by this author on:
Raphael T. Haftka,
Raphael T. Haftka
Department of Mechanical and Aerospace
Engineering,
University of Florida,
Gainesville, FL 32611
e-mail: haftka@ufl.edu
Engineering,
University of Florida,
Gainesville, FL 32611
e-mail: haftka@ufl.edu
Search for other works by this author on:
S. Balachandar
S. Balachandar
William F. Powers Professor
Department of Mechanical and Aerospace
Engineering,
University of Florida,
Gainesville, FL 32611
e-mail: bala1s@ufl.edu
Department of Mechanical and Aerospace
Engineering,
University of Florida,
Gainesville, FL 32611
e-mail: bala1s@ufl.edu
1Corresponding author.
Search for other works by this author on:
M. Giselle Fernández-Godino
Department of Mechanical and Aerospace
Engineering,
University of Florida,
Gainesville, FL 32611
e-mail: gisellefernandez@ufl.edu
Engineering,
University of Florida,
Gainesville, FL 32611
e-mail: gisellefernandez@ufl.edu
Frederick Ouellet
Department of Mechanical and Aerospace
Engineering,
University of Florida,
Gainesville, FL 32611
e-mail: f.ouellet@ufl.edu
Engineering,
University of Florida,
Gainesville, FL 32611
e-mail: f.ouellet@ufl.edu
Raphael T. Haftka
Department of Mechanical and Aerospace
Engineering,
University of Florida,
Gainesville, FL 32611
e-mail: haftka@ufl.edu
Engineering,
University of Florida,
Gainesville, FL 32611
e-mail: haftka@ufl.edu
S. Balachandar
William F. Powers Professor
Department of Mechanical and Aerospace
Engineering,
University of Florida,
Gainesville, FL 32611
e-mail: bala1s@ufl.edu
Department of Mechanical and Aerospace
Engineering,
University of Florida,
Gainesville, FL 32611
e-mail: bala1s@ufl.edu
1Corresponding author.
Contributed by the Fluids Engineering Division of ASME for publication in the JOURNAL OF FLUIDS ENGINEERING. Manuscript received November 1, 2018; final manuscript received February 25, 2019; published online April 8, 2019. Assoc. Editor: Samuel Paolucci.
J. Fluids Eng. Sep 2019, 141(9): 091302 (20 pages)
Published Online: April 8, 2019
Article history
Received:
November 1, 2018
Revised:
February 25, 2019
Citation
Fernández-Godino, M. G., Ouellet, F., Haftka, R. T., and Balachandar, S. (April 8, 2019). "Early Time Evolution of Circumferential Perturbation of Initial Particle Volume Fraction in Explosive Cylindrical Multiphase Dispersion." ASME. J. Fluids Eng. September 2019; 141(9): 091302. https://doi.org/10.1115/1.4043055
Download citation file:
Get Email Alerts
Cited By
Optimization of Exhaust Covers in Marine Scrubbers
J. Fluids Eng (December 2022)
Aerodynamics of Sweep in a Tandem-Bladed Subsonic Axial Compressor Rotor
J. Fluids Eng (December 2022)
Numerical Simulations of Fluid Transport in Heterogeneous Darcy–Forchheimer–Brinkman Layers
J. Fluids Eng (December 2022)
Flow Control for a Submerged Inlet
J. Fluids Eng (December 2022)
Related Articles
Application of the Particle Finite Element Method in Machining Simulation Discussion of the Alpha-Shape Method in the Context of Strength of Materials
J. Comput. Inf. Sci. Eng (March,2017)
Granular Flow and Heat-Transfer Study in a Near-Blackbody Enclosed Particle Receiver
J. Sol. Energy Eng (October,2015)
Physical Modeling for Selective Laser Sintering Process
J. Comput. Inf. Sci. Eng (June,2017)
Swirling Flame Combustion of Heavy Fuel Oil: Effect of Fuel Sulfur Content
J. Energy Resour. Technol (August,2021)
Related Proceedings Papers
Related Chapters
Modeling and Simulation of 3D Fireworks Based on Particle System
International Conference on Advanced Computer Theory and Engineering, 4th (ICACTE 2011)
A Novel Particle Swarm Optimizer with Kriging Models
Intelligent Engineering Systems Through Artificial Neural Networks, Volume 17
Adaptive Grayscale Morphological Operators for Image Analysis
Intelligent Engineering Systems Through Artificial Neural Networks, Volume 17